Cleaning; Cleaning The Body Of The Air Purifier; Cleaning The Air Quality Sensor; Cleaning The Pre-Filter - Philips AC2889/10R1 User Manual

5 Cleaning

Note
• Always turn the air purifier off and
unplug from the electrical outlet
before cleaning.
• Never immerse the air purifier in
water or any other liquid.
• Never use abrasive, aggressive, or
flammable cleaning agents such as
bleach or alcohol to clean any part
of the air purifier.
• Only the pre-filter is washable. The
air purification filter is not washable
nor vacuum cleanable.
• Do not attempt to clean the filters
or air quality sensor with a vacuum.
Cleaning the body of the
air purifier
Regularly clean the inside and outside
of the air purifier to prevent dust from
collecting.
1
Use a soft, dry cloth to clean both
the interior and exterior of the air
purifier.
2
The air outlet can also be cleaned
with a dry, soft cloth.
Cleaning the air quality
sensor
Clean the air quality sensor every
2 months for optimal functioning of the
purifier.
10 EN
Note
• If the air purifier is used in a dusty
environment, it may need to be
cleaned more often.
• If the humidity level in the room
is very high, condensation may
develop on the air quality sensor
and the air quality light may indicate
a more poor air quality even though
the air quality is actually good. If this
occurs, clean the air quality sensor
or use the air purifier on a manual
speed setting.
1
Switch off the air purifier and
unplug from the wall outlet.
2
Clean the air quality sensor inlet
and outlet with a soft brush (fig. u).
3
Open the air quality sensor cover
(fig. v).
4
Clean the air quality sensor, the
dust inlet and the dust outlet with a
damp cotton swab (fig. w).
5
Dry all parts thoroughly with a dry
cotton swab.
6
Reattach the air quality sensor
cover (fig. x).

Cleaning the pre-filter

Clean the pre-filter when F0 is displayed
on the screen(fig. y).
1
Switch off the air purifier and unplug
from the wall outlet.
2
Pull the bottom part of the front
panel to remove it from the air
purifier (fig. c).
3
Press the two clips down (1) and pull
the pre-filter towards you (2)(fig. d).
4
If the pre-filter is very dirty, use a
soft brush to brush away the dust
(fig. z). Then wash the pre-filter
under running tap water.