Putting The Player Together; Turntable Mat (Or Disc Slip Sheet); (Stylus Weight ※ 2 ) Center Spindle; Turntable - Technics SL-1200M3D Operating Instructions Manual

Locking nut

Putting the player together

Put the player together in the following order.
•Do not connect the AC power cord until set up is complete.
•Leave the dust cover off until set up and adjustments are com-
plete.
Fit the turntable
Put the turntable on the center spindle and then lay the mat on
top.
•Be very careful when putting the turntable on the main unit.
The magnet on the bottom of the turntable is finely adjusted
and sharp contact can cause it to move and lead to poor op-
eration. Ensure the magnet remains free from dust and iron
Magnet
particles.
•Do not adjust the screws attaching the magnet to the turn-
table. The rated performance of the unit cannot be guaran-
teed if the magnet is moved.
Securing
Attach the head shell
screws
Fit the head shell into the tone arm, keep it horizontal and tighten
the locking nut.
Attach the balance weight

tone arm.

If the cartridge weighs between 10 and 13 grams, attach the
included auxiliary weight
When the player is to be used for scratch play
Use the disc slip sheet
the record to be easily moved during play.
•Top (printed side): Lay the record on this side.
•Bottom: Slippery side.
For a different kind of slip
Put the transparent sheet
and turntable mat .
.
to the rear of the
to the main balance weight.
instead of the turntable mat. This enables
under the disc slip sheet.
5
RQT4912