Whirlpool HybridCare WED9290FW Installation Instructions Manual page 20

1.
Remove door from dryer
IMPORTANT: If the protective film has not yet been removed
from the dryer, peel the film from the dryer door before
proceeding.
Using a T25 screwdriver, remove the 4 screws securing the
®
door hinge to the dryer and lift up and out to remove the door.
Place the door on a soft towel or other non-scratch surface.
Reinstall the 4 screws in the holes.
2.
Move the door strike
Using a T25 screwdriver, remove the 2 screws securing
®
the door strike to the door frame of the dryer. Rotate the
strike 180° and attach to the opposite side of dryer door
frame as shown.
20
Reverse door swing curved glass – double handle
3.
Remove inner door from outer door
Position the door with the inside of the door facing up.
Using a Phillips screwdriver, remove the 10 screws securing
the inner door to the outer door. Lift off the inner door and
set aside.
4.
Remove hinge and latch
Using a T25 screwdriver, remove the 3 screws securing the
®
latch plate and latch backing plate and the 5 screws holding
the hinge assembly in place.
Latch
Hinge