Poulan Pro PP1150ES Owner's Manual page 5

ASSEMBLY / PRE-OPERATION
HOW TO SET UP YOUR SNOW THROWER
TOOL BOX (See Fig. 10)
A toolbox is provided on your snow thrower. The toolbox is
located on top of the belt cover. Store the extra shear bolts,
nuts and multi-wrench provided in parts bag in the toolbox.
NOTE: The multi-wrench may be used for assembly of the
chute rotator head to snow thrower and making ad just ments
to the skid plates.
UNFOLD UPPER HANDLE
1. Raise upper handle to the operating position and
tight en handle knobs securely. Additional carriage
bolts, washers and handle knobs are in bag of parts.
Use to secure upper handle to lower handle. Install
in lower holes in handles.
INSTALL SPEED CONTROL ROD (See Figs. 1 and 2)
1. Remove plastic tie securing rod to lower handle.
2. Insert rod into speed control bracket and secure with
retainer spring.
SPEED
CONTROL
ROD
PLASTIC TIE
UPPER
HANDLE
HANDLE
KNOB
LOWER
HANDLE
SPEED
CONTROL
BRACKET
FIG. 1
SPEED CON TROL ROD
RETAINER
SPRING
SPEED
CONTROL
LEVER
FIG. 2
INSTALL TRACTION DRIVE CONTROL ROD
(See Figs. 3 and 4)
The traction drive control rod is installed on the snow thrower.
1. Remove plastic tie securing traction drive control rod
to rotator bracket.
2. With top end of rod positioned under left side of control
panel, push rod down and insert top end of rod into
hole in traction drive control lever. Snap rod into place
by pushing down.
NOTE: Engage lever once and rod should snap into place.
TRACTION DRIVE CON TROL LEVER
5
PLASTIC TIE
TRACTION DRIVE
CONTROL ROD
FIG. 3
TRACTION DRIVE
CON TROL ROD
FIG. 4