• The required use of a GFI is normally related to the location of a receptacle with respect to any significant sources of water or moisture. • Viking Range, LLC will NOT warranty any problems resulting from GFI outlets which are not installed properly or do not meet the requirements below.
Proper Disposal (of old refrigeration unit) DANGER RISK OF CHILD ENTRAPMENT Before You Throw Away Your Old Refrigeration Unit: • Take off the doors. • Leave the shelves in place so that children may not easily climb inside. IMPORTANT: Child entrapment and suffocation are not problems of the past.
General Information Preparing Electrical Connections This appliance is not intended for use by persons (including children) with reduced All electrical instructions assume that outlet is physical sensory or mental capabilities, or located 4 to 10 inches from the floor. lack of experience and knowledge, unless A 115 volt, 60Hz, 15 amp circuit breaker and they have been given supervision or electrical supply are required.
Page 10
General Information Unpacking and Moving Unit CAUTION Do not cut cardboard sleeve covering the unit. Cutting may result in damage to the exterior of the cabinet. 1. Uncrate the unit outside on a flat level surface. Remove the cardboard sleeve by removing the banding holding the sleeve to the shipping base.
Anti-Tip Brackets WARNING Unit may tip forward if loaded racks/shelves are all pulled out at the same time. To prevent tipping and provide a stable installation, the unit must be secured in place with the anti-tip brackets provided with the unit. A set of metal anti-tip brackets are supplied with the unit. The anti-tip brackets, when properly installed should secure the rear legs and prevent the unit from tipping forward.
Installation CAUTION 4. Slide the cabinet into position, making sure the rear cabinet leveling legs slide Any finished flooring should be protected under the anti-tip devices. Push the with appropriate material to avoid damage cabinet into the opening until the bottom from moving the unit.
Kickplate Installation When the unit is secured in place, install the slotted kickplate. Secure slotted kickplate by snapping the latch into the latch catch on the unit. CAUTION The slotted kickplate must be removable for servicing. The floor cannot interfere with removal.
Installation Checklist IMPORTANT: To ensure a safe and proper installation, review below items directly with installer. □ Has all shipping tape, string and packing been removed? □ Has the unit been secured in place with the provided anti-tip bracket or is the unit 1 inch or less from a solid soffit? □...
• Name of dealer from whom purchased If you are unable to obtain the name of an authorized service agency, or if you continue to have service problems, contact Viking Range, LLC at (888) 845-4641 or write to: VIKING RANGE, LLC...
Page 16
Viking Range, LLC 111 Front Street Greenwood, Mississippi 38930 USA (662) 455-1200 For product information call 1-888-845-4641 or visit our web site at www.vikingrange.com in the US or www.brigade.ca in Canada F20868D EN (090115)