[Lens] - Panasonic PT-MZ13K Operating Instructions Manual

[CEILING]
Note
f Refer to "Angle sensor" (x page 35) for details on the range of the installation attitude that can be detected by the built-in angle sensor.

[LENS]

Perform the setting and operation regarding the projection lens.
[LENS TYPE]
When the projection lens is attached or replaced, confirm the [LENS TYPE] setting.
1) Press as to select [LENS].
2) Press the <ENTER> button.
f The [LENS] screen is displayed.
3) Confirm the type of the projection lens in [LENS TYPE].
Note
f The information of the projection lens is automatically acquired when the projector is turned on. The acquired information is displayed in
[LENS TYPE].
f [---] is displayed in [LENS TYPE] in following cases.
g When the automatic acquiring of the projection lens information has failed
f Even when the [PROJECTOR SETUP] menu → [LENS] → [ACTIVE FOCUS OPTIMIZER] → [ACTIVE FOCUS] is set to [ON], the active
focus optimizer function will not operate if [---] is displayed in [LENS TYPE].
f Turn off the projector and reattach the projection lens when [---] is displayed in [LENS TYPE].
[LENS MEMORY]
The adjusted lens position (vertical position, horizontal position, focus position, zoom position, and periphery focus
position) can be saved and loaded.
Saving lens position
1) Press as to select [LENS].
2) Press the <ENTER> button.
f The [LENS] screen is displayed.
3) Press as to select [LENS MEMORY].
4) Press the <ENTER> button.
f The [LENS MEMORY] screen is displayed.
5) Press as to select [LENS MEMORY SAVE].
6) Press the <ENTER> button.
f The [LENS MEMORY SAVE] screen is displayed.
f If the lens memory has already been saved, the name of the saved lens memory and its lens position
information ([VERTICAL POSITION]/[HORIZONTAL POSITION]/[FOCUS POSITION]/[ZOOM POSITION]/
[PERIPHERY FOCUS POSITION]) are displayed in the [LENS MEMORY SAVE] screen.
7) Press as to select the item to save, and press the <ENTER> button.
f The confirmation screen is displayed.
f Current lens position information ([VERTICAL POSITION]/[HORIZONTAL POSITION]/[FOCUS POSITION]/
[ZOOM POSITION]/[PERIPHERY FOCUS POSITION]) is displayed in the confirmation screen.
8) Press qw to select [OK], and press the <ENTER> button.
f The [LENS MEMORY NAME INPUT] screen is displayed.
9) Press asqw to select the text, and press the <ENTER> button to enter the text.
124 - ENGLISH
Chapter 4 Settings — [PROJECTOR SETUP] menu
Select this item when installing the projector using the Ceiling Mount Bracket (optional).
Projected image is inverted upside down.