Advertisement
23528_8820-00380_F7D4302 v1_Play Router_Updated_0222-2010
2)
If your ISP requires a user name and password, make sure that
you have typed in your user name and password correctly.
Some user names require that the ISP's domain may be at the
end of the name. Example: "myname@myisp.com". The
"@myisp.com" part of the user name may need to be typed as
well as your user name.
3) If you continue to have no Internet connection, refer to
"Manually Configuring Network Settings" in this manual for an
alternative setup method.
Belkin Setup completed installation, but I cannot browse the Web. The light on
the front of my Router is blinking amber.
1) Make sure the Router is connected to your modem with an
Ethernet cable via the Router's one WAN (modem) port.
2) Unplug the modem from its power source and make sure that
it goes dark. Then reapply power to the modem.
3) Unplug your Router's power supply, wait 10 seconds, and
plug it back in. This will cause the Router to try to reestablish
communication with the modem.
Belkin Setup completed installation, but I cannot browse the Web. The light on
the front of my Router is solid amber.
1) Use the troubleshooting suggestions within Belkin Setup.
2)
If your ISP requires a user name and password, make sure
that you have typed in your user name and password
correctly. Some user names require that the ISP's domain
may be at the end of the name. Example:
"myname@myisp.com". The "@myisp.com" part of the
user name may need to be typed as well as your user name.
3)
If you have a static connection, your ISP will have assigned
you an IP address, subnet mask, and gateway address.
Please re-run Belkin Setup and enter this information when
a static connection is mentioned.
Advertisement
