System Preparation - Sharp HT-SB31D Operation Manual

System preparation

Make sure to unplug the AC power cord before
installing the sound bar or changing the position.
To mount the sound bar on the wall
Caution:
●
Be very careful to prevent the sound bar [3.8 lbs.
●
put on the veneer plaster or whitewashed wall. The
service technician.
●
Mounting screws are not supplied. Use appropri-
ate ones.
●
Check all wall mount angle screws for looseness.
●
Select a good location. If not, accidents may occur
or the sound bar may get damaged.
●
SHARP/Hisense are not responsible for acci-
dents resulting from improper installation.
■ Driving screws
SHARP designed the sound bar so you may hang
it on the wall. Use proper screws (not supplied).
See below for size and type.
1/8" (3.2 mm)
3/16"
3/8" (9 mm)
(5 mm)
Min. 7/8" (22 mm)
■ Installing the sound bar
1
Fix the pattern paper to the wall in hori-
509 mm
21-5/8" (548 mm)
Wall surface
44 mm
Pattern paper
(supplied)
2
Make a hole on the wall following the screw
point marks on the pattern paper by using
a drill.
3/8" (8-9 mm)
3
Fix a wall mount plug into the hole using
surface.
1-1/4" (32 mm)
3/8" (8-9 mm)
4
Fasten the screws to the wall as shown below.
Wall surface
Wall surface
5
Hang the sound bar onto the screws.
E-8
1-1/4" (32 mm)
Wall surface
Wall sur
face
Screw using
screwdriver
3/16" (4.5 mm - 5 mm)
Gap from wall
surface