Specifications - LG DT21WS Owner's Manual

44

SPECIFICATIONS

Before Calling For Service (cont.)
Problem
TM
FLOW SENSE • Ductwork is too long or has too
indicator many turns/restrictions.
shows four
• Significant blockage of the
bars during the ductwork due to lint buildup or
drying cycle debris.
or the display • The appliance has detected a
shows "d80" restriction in the external dryer
after drying. venting.
The display • The duct work is about 90%-95%
shows blocked.
"d90", "d95" ("d90" or "d95" error code
displayed 2 hours only)
• House exhaust system blocked.
SPECIFICATIONS
Models
Description
Electrical requirements
Gas requirements
Dimensions
Net weight
Drying capacity
- Normal cycle
Possible Causes
DT21WS
Dryer
120 V~ 60 Hz 400 W
NG 4-10.5 inches WC
LP: 8–13 inches WC (Gas Models only)
27" (W) X 28 15 / 16 " (D) X 40 3 / 16 " (H), 50 1 / 4 " (D with door open)
68.6 cm (W) X 73.4 cm (D) X 102 cm (H), 127.5 cm (D with door open)
Gas dryer : 121.2 lb (55 kg)
Electric dryer : 118.8 lb (53.9 kg)
207 L , IEC 7.3 cu.ft. (22.5 lb/10.2 kg)
• Install a shorter or straighter duct run. See the Installation
Instructions.
• Ductwork should be checked/cleaned soon.
Dryer can be used in this condition, but drying times may
be longer.
• If exhaust restrictions are sensed by the FlowSense™
system, the indicator will remain on for two hours after
the end of the cycle. Opening the door or pressing the
POWER button will turn off the display.
• Do not use the dryer until the exhaust system has been
cleaned and/or repaired. Using the dryer with a severely
restricted exhaust is dangerous and could result in a fire
or other property damage.
• Check the outside dryer vent while the dryer is operating
to make sure there is strong airflow.
• If the exhaust system is extremely long, have it repaired or
rerouted.
• Keep the area around the dryer clean and free of clutter.
• Check vent hood for damage or lint clogging.
• Make sure the area around the vent hood is clear.
Solutions