ASROCK iBOX-155 Quick Installation Manual page 2

1. Removing the Top Cover
1. Remove the six screws on the front and rear
panels.
2. Li up and remove the top cover.
2. Installing the SO-DIMM
1
2
2
* Please install the SO-DIMM module into the
DDR3_A2 for the rst priority.
3. Installing the Hard Drive
1. Release the four screws to remove the hard drive
bracket.
2. Place a HDD into the bracket with the printed
circuit board side facing down. Secure the hard
drive into the place using the four screws.
3. Place the bracket into the chassis. Carefully align
the mounting holes on the bracket and the chassis.
Secure the bracket into the place using the four
screws.
4. A ach the SATA data cable and power cable
to the motherboard.
4. Installing the WiFi module
* is step is optional.
1. Based on the length of the WiFi Module Card,
release and move the stando by hand to the nut
to be used .
2. Insert the WiFi Module Card into the mini
PCI Express slot (MINI_PCIE1). Tighten the
screw that holds the card in place.
5. Installing the WiFi antennas
* is step is optional.
1 A ach the SMA Wi-Fi Antenna Cables to the
WiFi Module.
2. Connect the two WiFi 2.4/5 GHz Antennas to
the antenna connectors. Turn the antenna
clockwise until it is securely connected.
SATA Power
Output Connector
SATAII_1
3. Set the WiFi 2.4/5 GHz Antenna at 90-degree
angle.
*You may need to adjust the direction of the
antenna for a stronger signal.
6. Replacing the Bottom Cover
1. Replace the top cover.
Note
2. Secure the six screws on the front and rear panels.
For more details on the hardware installation,
please refer to the User Manual in the support CD.
e terms HDMI™ and HDMI High-De nition
Multimedia Interface, and the HDMI logo are
trademarks or registered trademarks of HDMI
Licensing LLC in the United States and other
countries.