Table of Contents
Advertisement
2.6 Onboard Headers and Connectors
Onboard headers and connectors are NOT jumpers. Do NOT place
jumper caps over these headers and connectors. Placing jumper caps
over the headers and connectors will cause permanent damage of the
motherboard!
SATA3 Connector
(SATA3_1: see p.8, No. 24)
USB 2.0 Connectors
(9-pin USB2_4_5, USB2_6_7)
(see p.8 No. 30)
USB2_6_7 is shared with MINI_PCIE1. If you use USB2_6_7 connector,
the USB device on MINI_PCIE1 will be disabled.
System Panel Header
(9-pin PANEL1)
(see p.8 No. 13)
Connect the power switch, reset switch and system status indicator on the
chassis to this header according to the pin assignments below. Note the
positive and negative pins before connecting the cables.
PWRBTN (Power Switch):
Connect to the power switch on the chassis front panel. You may configure
the way to turn off your system using the power switch.
RESET (Reset Switch):
Connect to the reset switch on the chassis front panel. Press the reset
switch to restart the computer if the computer freezes and fails to perform a
normal restart.
SATA3_1
USB_PWR
-B
+B
GND
DUMMY
1
GND
+A
-A
USB_PWR
PLED+
PLED-
PWRBTN#
GND
1
GND
RESET#
GND
HDLED-
HDLED+
17
This Serial ATA3
(SATA3) connector supports
SATA data cables for internal
storage devices. The current
SATA3 interface allows up to
6.0 Gb/s data transfer rate.
There are two USB 2.0
connectors on this
motherboard. Each USB 2.0
connector can support two USB
ports.
This header accommodates
several system front panel
functions.
Advertisement
Table of Contents
