TEC SL-9000 Owner's Manual page 91

16. ERROR MESSAGE TABLE
●
Label lssue Mode
Message
DATA ENTRY ERROR
PLU NOT FOUND
TOTALS OVERFLOW
MEMORY WILL BE
FULLED
PLU DATA ERROR
PRT FAILURE DETECTED Printer trouble.
LABEL OVER RUN
●
Report and Reset Mode
Message
PLU NOT FOUND
PRT FAILURE DETECTED Printer trouble.
LABEL OVER RUN
Cause
Error in key input.
The PLU # being called out is
not registered.
GRAND TOTAL or PLU TOTAL
memory has been exceeded at
the time of issuing a label.
The machine judges the
memory is full before
designated number of media
are printed in Batch mode.
Error in the PLU data.
Media end.
Label overruns.
Cause
Corresponding PLU # is not
registered.
Label overruns.
16- 2
16. ERROR MESSAGE TABLE
Solution
Press the key, and re-input the right
C
data.
C
Press the key, and check the PLU #.
C
Press the key, then the
select 'RESET'.
exceeded memory.
Press the key, then the
C
select 'RESET'. Then sum up the
exceeded memory.
Press the key, and reprogram PLU
C
data.
1. Check that the label and print head are
set correctly.
2. If the label home position is misaligned,
press the key.
FEED
FEED
Press the key.
Solution
Press the C key, and enter the correct
PLU #.
Same as in the label issue mode.
Press the key.
FEED
ESC.
key and
Then sum up the
key and
ESC.