The relationship between the network variables and input terminals is shown in below.
Variables
nvoDigitalIn1
nvoDigitalIn2
nvoDigitalIn3
nvoDigitalIn4
nvoDigitalIn5
nvoDigitalIn6
nvoDigitalIn7
nvoDigitalIn8
6.6.16. nvoAnalogIn1 to 3 (Analog Input Monitor)
Output network variable
SNVT type: SNVT_lev_percent (81)
They provide the inverter analog input terminal state in percentage.
- Valid range: 0.000 to 100.000%
- Unit: 0.005% (The resolution depends on the inverter specification)
The adjustment of analog input value is possible to set the inverter parameter (f470 to f475) (Refer
to the inverter instruction manual for details).
The relationship between the network variable and the terminal is shown in the table below.
Name
nvoAnalogIn1
nvoAnalogIn2
nvoAnalogIn3
When RR/S4 terminal has Logic input terminal function, "nvoAnalogIn1" always shows 0.000%.
6.6.17. nvoEmergStatus (Emergency Status)
Output network variable
SNVT type: SNVT_have_emerg (103)
It provides the response against an emergency stop of the inverter (nviEmergOverride). When the node
received "nviEmergOverride" network variable, it propagates the information to the network.
- Valid range
Value
0
1
2
3
4
5
6 to 255
LIU007Z
F terminal
R terminal
-------
-------
-------
-------
-------
-------
LIU007Z
-----
VIB terminal
-----
Status
Trip release
EMERG_NORMAL (No Emergency mode)
EMERG_PRESSURIZE (Emergency pressurize mode)
EMERG_DEPRESSURIZE (Emergency depressurize mode)
EMERG_PURGE (Emergency purge mode)
Emergency stop
EMERG_SHUTDOWN (Emergency shutdown mode)
EMERG_FIRE (Emergency fire mode)
---
LIU006Z
Under Development
LIU006Z
Under development
Description
- 31 -
E6581373