Table of Contents
Advertisement
5. After installing the bracket on the main unit, tighten the screws.
6. Connect the power cable of the hard disk.
7. Connect the SATA cable to the hard disk.
<Connecting power cable>
8.
Connect the SATA cable to the SATA port of the main board.
9. Close the cover of the main unit.
10. Tighten the screws.
11. After installing the hard disk, you must format the hard disk from the setting menu.
<LE6016N>
-
The first SATA cable port on the main board must be connected at all times. If a hard disk is
not connected, this device may not operate normally.
Hard disk replacement
First turn off the power of the device and then unplug the power.
1. Loosen the screw on the left, right and rear side of the product.
2. Separate the cover of the main unit.
<Connecting SATA cable>
<LE6016D>
Before use
19
2
Advertisement
Table of Contents
