RIDGID R4113 Operator's Manual page 28

OPERATION
 Tighten the fence screws to secure the fences in place.
 Set the bevel angle at 0° and the miter angle at 45° to
either the left or the right.
 Nest and secure the crown molding against the back of
a sliding miter fence, as shown in figures 37 and 38.
 Position the crown molding in place by using the work
clamp as a material stop.
 Tighten the knob on the work clamp until it rests lightly
against the edge of the molding. Do not overtighten as
this may move the material causing misalignment.
 Hold the workpiece as shown in figure 37 with your hand
on the outside of the sliding miter fence.
 Before turning on the saw, perform a dry run of the cut-
ting operation to make sure that no problems will occur
when the cut is made.
 Grasp the saw handle firmly. Depress the trigger lockout
lever and squeeze the switch trigger. Allow several sec-
onds for the blade to reach maximum speed.
 Slowly lower the blade into and through the crown mold-
ing.
 Release the switch trigger and allow the saw blade to
stop rotating before raising the blade out of the crown
molding and removing the crown molding from the miter
table.
SLIDING
MITER FENCE
MOLDING
WORK CLAMP
SLIDING
MITER FENCE
LARGE CROWN MOLDING NESTED AGAINST
LARGE
FENCE SCREW
Fig. 37
28 - English
BOTTOM EDGE AGAINST FENCE =
RIGHT SIDE, INSIDE CORNER
LEFT SIDE, OUTSIDE CORNER
MITER TABLE
REAR FACING MITER FENCE
SLIDING
MITER FENCE
SLOT
VIEW OF SAW FROM BEHIND WITH
FENCES FACING FORWARD
WORK CLAMP
Fig. 38
Fig. 39