RIDGID R4113 Operator's Manual page 21

OPERATION
LED LIGHTING SYSTEM
See Figure 24.
WARNING:
Do not stare into the light beam (not even from a
distance). Staring into the light beam may result in
serious injury or vision loss.
The LED lighting system casts the shadow of the blade onto
the workpiece. This results in greater accuracy of cuts and
requires no adjustments.
To use this feature, turn the LED switch on.
Bring the saw arm down so the blade is approximately
1/4 in. from the workpiece. The shadow of the blade will be
projected onto the workpiece, indicating where the blade
teeth will make contact as the cut is made.
TO MITER CUT/CROSS CUT
See Figures 25 - 26.
A cross cut is made by cutting across the grain of the
workpiece. A straight cross cut is made with the miter table
set at the 0° position. Miter cross cuts are made with the
miter table set at some angle other than zero.
NOTE: It may be necessary to adjust the sliding miter fence
to ensure proper clearance prior to making the cut.
 Pull out the lock pin and lift saw arm to its full height.
 Lift the miter lock lever, then depress and hold the detent
release button to release the miter table.
 Rotate the control arm until the pointer aligns with the
desired angle on the miter scale.
 Release the detent release button, then push the miter
lock lever down to secure the miter table.
NOTE: You can quickly locate 0°, 15°, 22-1/2°, 31.6°, and
45° left or right by releasing the detent release button as
you rotate the control arm. The control arm will seat itself
in one of the positive stop notches, located in the miter
table base.
 Place the workpiece flat on the miter table with one edge
securely against the fence. If the board is warped, place
the convex side against the fence. If the concave edge
of a board is placed against the fence, the board could
collapse on the blade at the end of the cut, jamming the
blade. See Figures 41 - 42.
 When cutting long pieces of lumber or molding, support
the opposite end of the stock with a roller stand or with
a work surface level with the saw table. See Figure 30.
 Turn the LED switch on.
 Lower the blade and align the cutting line on the workpiece
with the edge of saw blade or the blade shadow.
 Grasp the stock firmly with one hand and secure it against
the fence. Use the work clamp, C-clamp, or other suitable
clamp to secure the workpiece when possible.
SHADOW OF BLADE
TEETH PROJECTED
ONTO WORKPIECE
WORK
CLAMP
21 - English
SWITCH
CROSS CUT
MITER
LOCK LEVER
DETENT
RELEASE BUTTON
LED
Fig. 24
Fig. 25