Table of Contents
Advertisement
2
G etting started
2.1
Inserting the batteries
•
I nsert 2 AAA type batteries,
noting the + and -
configuration in the battery
compartment.
Note
When replacing the batteries, all user settings will be
retained in the remote control memory for 5 minutes.
2.2
Setting up the universal remote control
The example below instructs you how to set up your
universal remote controls for your TV.
You can repeat the same steps for other devices (STB, DVD
player/recorder and VCR) which you want to operate, using
the SRP4004.
The remote control can be set up to operate any 4 of the
following devices:
Device name
Description
TV
T raditional TV, flat screen TV and
projection TV, TV part of TV / VCR, TV /
VCR / DVD and TV / DVD combos
STB
C able box, satellite receiver, Digital
Video Broadcasting Terrestrial device
(DVB-T), Internet Protocol TV
(IPTV), Free To Air TV, High Definition
Television decoder (HDTV)
DVD
D VD player / recorder (DVDR), DVD /
Hard Disk Drive combination (DVDR-
HDD), Blu-Ray player, High Definition
DVD player (HD-DVD), DVD part of
TV / DVD, TV / VCR / DVD and VCR /
DVD combos
VCR
V ideo cassette player / recorder, VCR
part of TV / VCR, TV / VCR / DVD and
VCR / DVD combos
EN
4
Example: s etting up the universal remote control to
operate your TV:
1
S witch ON the TV manually or use the original remote
control for this. Tune to channel 1.
2
P ress and hold the
device selection button
for 5 seconds until the red
Setup LED lights up.
The remote control is now
in setup mode.
3
L ook up the 4-digit
code for your brand in the
brand list at the back of this
user manual.
A four-digit code is shown
for each brand.
U se the digit buttons to
enter the code for your
brand.
• I f the red Setup LED
turns off, an invalid code
was entered. In this case,
try again.
4
A im the remote control at
the TV. Press and hold the
button. Release it
immediately as soon the TV
switches off.
• T his step normally
takes between 5 and 60 seconds. In extreme
circumstances this step can take up to 15 minutes.
5
S witch ON the TV.
Try out the buttons you
need for operating it. Try, for
example, if the - CH + and
digit buttons function
properly.
• I f a button does not work as expected, press and hold
that button. Release it immediately as soon as it works.
For more information, see chapter 2.2.2.
6
P ress the
device
selection button twice to
finish setup.
•
W hen no button is
pressed for 5 minutes
or more, the remote
control will exit setup
mode, automatically saving all your settings.
5 sec.
5-60 SEC.
5 - 60 sec.
2 x
EN
5
Advertisement
Table of Contents
