Setting Up The Universal Remote Control - Philips SRP2002/10 User Manual

2.2 Setting up the universal remote control
The example below instructs you how to set up your
universal remote control for your TV. You can repeat the
same steps for other devices (DVD player/recorder and
VCR) which you want to operate, using the SRP2002.
The remote control can be set up to operate any 2 of the
following devices:
Device name Description
TV T raditional TV, flat screen TV and
projection TV, TV part of TV/VCR, TV/
VCR/DVD and TV/DVD combos
DVD D VD player, Blu-Ray player, High
Definition DVD player (HD-DVD),
DVD part of TV/DVD, TV/VCR/DVD
and VCR/DVD combos
VCR V ideo cassette player/recorder, VCR
part of TV/VCR, TV/VCR/DVD and
VCR/DVD combos
Example: s etting up the universal remote control to
operate your TV:
1
S witch ON the TV manually or use the original remote
control for this. Tune to channel 1.
2
P ress and hold the
device selection button
for 5 seconds until the green
Setup light lights up.
• T he remote control is
now in setup mode.
3
L ook up the 4-digit code for
your brand in the brand list
at the back of this user
manual.
A four-digit code is shown
for each brand.
U se the digit buttons to
enter the code for your
brand.
• I f the green Setup light
turns off, an invalid
code was entered. In
this case, try again.
EN
4
5 sec.
4
A im the remote control at
the TV. Press and hold the
button. Release it
immediately as soon as the
TV switches off.
• T his step normally
takes between 5 and 60 seconds. In extreme
circumstances this step can take up to 15 minutes.
5
S witch ON the TV. Try out
the buttons that you need
for operating it. Try, for
example, if the , and
digit buttons function
properly.
• I f a button does not work as expected, press and hold
that button. Release it immediately as soon as it works.
For more information, see chapter 2.2.2.
6
P ress the device
selection button twice to
finish setup.
• W hen no button is
pressed for 5 minutes
or more, the remote
control will exit setup mode, automatically saving all
your settings.
Important
If you made a mistake:
• P ress the device selection button twice to exit setup.
The green Setup light turns off.
• Restart from the beginning.
• If the device does not respond at all or not to all of the
button commands or if you cannot find the code for your
brand, enter '9, 9, 9, 9' in step 3 and continue with step 4.
The remote control will now search its full database for a
code that works with your TV. Full database search may
take up to 15 minutes.
2.2.1 S etting up the remote control for other devices
(DVD player/recorder and VCR)
1
M ake sure the device is switched on and operational.
E.g. insert a disc in the DVD player/recorder or a video
cassette in the VCR.
2
T hen follow steps 2 to 6 of 'Setting up the remote
control for your TV'. Make sure to use the correct device
selection button: .
5-60 SEC.
5 - 60 sec.
2 x
EN
5