Timer Programming - Panasonic TX-32FSF607 Manual

Timer Programming

This function allows you to select programmes that you want to record to the
USB HDD.
1. Display TV Guide
2. Select the forthcoming programme and press
You can also set a timer event pressing
●
To check / change / cancel a timer event
●
Recording > Timer Programming > Editing Timer Programming
LED turns to orange in Standby mode when
●
To return to TV Guide
●
BACK/RETURN
If you select the current programme, a confirmation screen asking
●
whether you want to watch or record the programme appears. Select
Timer Programming
the time you finish the timer event setting.
is displayed on the TV Guide screen if
●
from TV Guide.
Depending on the country you select, you can set
●
Recording (see below).
= Note =
Not valid in Analogue
●
Timer Programming
●
received via the signal from the broadcaster or service provider.
No other channels can be selected while recording of
●
is in progress.
When recording programmes to the USB HDD, be sure to format the USB
●
HDD and enable it to record in
Recording > USB HDD setup
■
Signal Supported Recording
Signal Supported Recording
information from the TV Guide; if programme start and end times are changed
by the broadcaster, the timer event will follow the change. Note that
Supported Recording
from broadcasters.
The availability of this function depends on the country and TV mode you
●
select.
with GUIDE.
and press OK
only works reliably if correct time information is
USB Device
is Timer Programming
only works reliably if correct information is received
- 87 -
OK to access.
.
Timer Programming
to set USB HDD Rec.
Timer Programming
Signal Supported
Timer Programming
Setup.
which is controlled by
is set.
to record from
is set
Signal