Setup Devices; Use Philips Easylink - Philips 220TW9FB/05 Manual

7�4

Setup devices

Assign a channel decoder
Decoders that decode channels can be
connected to SCART. You have to assign the
TV channel as a channel to be decoded. Then
assign the connection where the decoder is
connected.
1. Press MENU on the remote control and
select Install > Decoder.
TV menu
Install
Language
Country
Channel installation
Preferences
Source labels
Decoder
Current software info
Factory reset
2. Press Æ to enter the list.
3. Press Î or ï to select the channel to
decode.
4. Press OK to select or unselect the channel.
5. Press Í to return to the previous menu.
6. Press MENU to exit.
PHILIPS
Decoder
1 ......
2 ......
7�5

Use Philips EasyLink

Your TV Monitor supports Philips EasyLink,
which enables one-touch play and one-touch
standby between EasyLink-compliant devices.
Compliant devices must be connected to your
Product via HDMI and assigned as described in
Section 7.4.1 Assign devices to connectors.
Enable or disable EasyLink
1. Press MENU on the remote control then
select Install > Preferences > EasyLink.
2. Select On or Off.
Use one-touch play
One-touch play enables you to press the play
button on, for example, your DVD remote
control. This starts playback on your DVD
device and automatically switches your TV to
the correct source, displaying DVD content.
Use System standby
System standby enables you to press and hold
the POWER button on, for example, your TV
Monitor remote control. This switches your TV
Monitor and all connected HDMI devices on
or to standby mode. You can perform system
standby using remote controls from any of the
connected HDMI devices.
EN-35