Table of Contents
Advertisement
132996510.qxd
11/07/01
Installation
Unpacking
All transit bolts and packing must be removed before using the appli-
ance.
Using a spanner, unscrew and remove the
rear right-hand bolt and lay the machine on
its back, taking care not to squash the hoses.
This can be avoided by placing one of the
corner packing pieces between the machine
and the floor.
Remove the poly-
styrene block
from the bottom
of the machine
and release the
two plastic bags
which are fixed
under the filter
door.
Carefully remove
the right-hand bag (1) then the left-hand bag (2) by pulling them towards
the centre of the machine.
Set the machine
upright and remove
the two remaining
bolts from the
back.
Pull out the three
plastic spacers from
the holes into
which the bolts
were fitted.
Plug the open holes with the plugs which you will find in the plastic bag con-
taining the instruction booklet.
You are advised to keep all transit devices so that they can be refitted if the
machine ever has to be transported again.
15.30
Pagina
83
(Nero/Process Black pellicola)
83
Hide quick links:
Advertisement
Table of Contents
