EasyPro SFL10 Instructions For Operation

Submersible, Cool White, Low Voltage • SFL10
Underwater LED Light
Instructions for Operation • Safety • Warranty
Thank you for purchasing an EasyPro submersible LED pond and fountain light. With this
cool white LED light you can make your fountain glow, illuminate your pond from within,
highlight your waterfall and extend the enjoyment of your water feature in the evening
hours. The SFL10 can be used in the landscape out of the water or as a submersible
underwater light. The SFL10 has a one year limited warranty.
SFL10 Specs:
1. Stainless steel housing
2. Integrated driver
3. Power usage at 12V AC: 9 watts
4. Cool white LED
5. 3 conductor wire (yellow or black
is ground)
6. 1 year warranty (12 vac
transformer required)
7. Dual 1" fpt on top and bottom for
direct connection to plumbing
Safety and Electrical Connections:
1. Always disconnect the electrical supply before handling, maintaining, repairing
or installing any pond equipment.
2. Light(s) must be attached to a 12 volt AC transformer.
3. Never hook the lights directly to a 120 volt or higher outlet.
4. Connect the transformer only to a 120 volt receptacle that is protected by a Ground
Fault Circuit Interrupter (GFCI).
5. Do not use this product in bathrooms or swimming pools.
6. All electrical work must be performed by a qualified technician. Always follow the
National Electrical Code (NEC) or the Canadian Electrical Code as well as all local,
state and provincial codes. Code questions should be directed to your local electri-
cal inspector. Failure to follow electrical codes and OSHA safety standards may result
in personal injury or equipment damage. Failure to follow manufacturer's installation