Smeg SI2M7953D User Manual page 18

18
outer edge of the glass ceramic. Do
not extend it. Make sure that the ends
of the seal stripe are located in the
middle of one side of the hob.
3. Add some mm when you cut the seal
stripe to the length.
4. Push the two ends of seal stripe
together.
Attaching the seal - Integrated
installation
1. Clean the rabbets in the worktop.
2. Cut the supplied thicker seal stripe
into 4 stripes. The stripes must have
the same length as the rabbets.
3. Cut the ends of the stripes at an angle
of 45°. They should fit in the corners of
the rabbets accurately.
4. Attach the stripes to the rabbets. Do
not extend the stripes. Do not bond
ends of stripes one over another.
After you assemble the hob, seal the
remaining gap between glass ceramic and
the worktop with silicone. Make sure the
silicone does not get under the glass
ceramic.
Assembly
min.
500mm
On-top installation
1.
min.
50mm
If the appliance is installed
above a drawer, the hob
ventilation can warm up the
items stored in the drawer
during the cooking process.
You can instal a separation
panel but it is not mandatory.
R 5mm
mm 880
+1
490
min.
55mm
min. 60mm
+1
mm