Table of Contents
Advertisement
Adjusting your monitor image
Using the direct access controls
Using the On-Screen Display (OSD) controls
2-3 LI2215s Flat Panel Monitor User's Guide
This section describes the user control features used to adjust your monitor image.
The direct access controls can be used when the On Screen Display (OSD) is not displayed.
Table 2-1. Direct access controls
Icon
DDC-CI
Exit
Auto Adjustment
Novo Vision
Low Blue Light
Enter
The settings adjustable with the user controls are viewed through the On-Screen Display (OSD),
as shown below.
Brightness/Contrast
Brightness
Exit
Left
To use the controls:
1.Press
to open the main OSD menu.
2.Use
or
to move among the icons. Select an icon and press
function. If there is a sub-menu, you can move between options using
press
to select that function. Use
save.
3.Press
to move backwards through the sub-menus and exit from the OSD.
4.Press and hold
for 10 seconds to lock the OSD. This will prevent accidental
adjustments to the OSD. Press and hold
adjustments to the OSD.
5.Enables DDC/CI by default. Use OSD Exit Key, press and hold the
seconds to disable/enable DDC/CI function. The words " DDC/CI
Disable/DDC/CI/Enable" shows on the screen.
Control
Press and hold for 10 seconds to enable or disable the
DDC-CI function
Exit and return to previous level
Optimizes image (size, position, phase and clock) (For
analog [VGA] source only)
Hot key to fantasy mode.
Press and hold for 3 seconds to enable/disable
Low Blue Light.
Press to enter next level on main menu/sub menu status
or enter previous level on adjustment bar
Contrast
Right
OK
or
for 10 seconds to unlock the OSD and allow
Description
to access that
or
to make adjustments. Press
buttons for 5
, then
to
Advertisement
Table of Contents
