Table of Contents
Advertisement
Quick Links
3/8" AIR ANGLE DRILL
Model 2439
ASSEMBLY and OPERATING
INSTRUCTIONS
Due to continuing improvements, actual product may differ slightly from the product described herein.
3491 Mission Oaks Blvd., Camarillo, CA 93011
Visit our Web site at http://www.harborfreight.com
Copyright
2002 by Harbor Freight Tools
. All rights reserved. No portion of this
©
®
manual or any artwork contained herein may be reproduced in any shape or form
without the express written consent of Harbor Freight Tools.
For technical questions and replacement parts, please call 1-800-444-3353
Manual Revised 11h
Advertisement
Table of Contents
Related Manuals for Central Pneumatic 2439
Summary of Contents for Central Pneumatic 2439
-
Page 1: Assembly And Operating
3/8” AIR ANGLE DRILL Model 2439 ASSEMBLY and OPERATING INSTRUCTIONS Due to continuing improvements, actual product may differ slightly from the product described herein. 3491 Mission Oaks Blvd., Camarillo, CA 93011 Visit our Web site at http://www.harborfreight.com Copyright 2002 by Harbor Freight Tools . -
Page 2: Specifications
Wear a full face shield if you are producing metal filings or wood chips. Wear an ANSI approved dust mask or respirator when working around metal, wood, and chemical dusts and mists. SKU 2439 1/4” - 18 NPT 90 PSI 4.5 SCFM... - Page 3 20. Compressed air only. Never use combustible gases as a power source. Note: Performance of the compressor (if powered by line voltage) may vary depending on variations in local line voltage. Extension cord usage may also affect tool performance. SKU 2439 Page 3...
-
Page 4: Operation
1. You will need to prepare a 1/4” air connector (sold separately) to connect to the Air Inlet (12) on the Angle Drill. First, wrap the 1/4” air connector (not included) with pipe thread seal tape before connecting to a 3/8” ID Air Source Hose (not included). Connect the Air Source Hose to the Angle Drill. -
Page 5: Maintenance
Operation Note: This drill can be used to get into hard to reach places with it’s angular configuration. It may also be used just like a traditional drill. This drill does not have a reverse drive. Warning! Always disconnect the unit from the air compressor when changing bits. -
Page 6: Parts List
PARTS THERETO, OR ARISING OUT OF HIS OR HER INSTALLATION OF REPLACEMENT PARTS THERETO. NOTE: Some parts are listed and shown for illustration purposes only and are not available individually as replacement parts. SKU 2439 Parts List Qty. Part No. -
Page 7: Assembly Drawing
Assembly Drawing Page 7 SKU 2439... - Page 8 This warranty gives you specific legal rights and you may also have other rights which vary from state to state. Page 8 SKU 2439...