Samsung RL22 Series User Manual page 22

Do not use without the molded end (Bulb)
CAUTION
1. T
compression fi tting.
2. Turn water on and check for any leakage. If you
fi nd water drops or leakage in the connection
areas, turn o the main water supply. Check
the connections and, if necessary, tighten.
3. Flush 1 gallon of water through the fi lter before
drinking or using the water from the refrigerator.
(Flush approximately 6 minutes.) To fl ush, press
a large glass or cup against the water dispenser
lever. Fill the glass, empty it into the kitchen sink
after it is fi lled, and then repeat.
4. After you turn on the refrigerator, let the ice
maker make ice for 1 to 2 days. Over that
period of time, throw out the fi rst 1 or 2 buckets
of ice the freezer makes to ensure all impurities
have been removed from the water line.
Only connect the water line to a drinkable
water source.
If you have to repair or disassemble the water line,
get a snug, leak-free connection.
22_ setting up
COMPLETING THE SET UP
B
Now that you have your new refrigerator installed
in place, you are ready to set up and enjoy the
B
features and functions of the appliance.
By completing the following steps, your refrigerator
B
should be fully operational.
1. Make sure your refrigerator is in an appropriate
2. Once the refrigerator is plugged in, make sure
3. Set the Temperature control to the coldest
4. After you plug the refrigerator in, it will take a
location with reasonable clearance between it
and the wall. Refer to installation instructions in
this manual.
the interior light comes on when you open the
doors.
temperature and wait for an hour. The freezer
will get slightly chilled and the motor will run
smoothly. Reset the refrigerator and freezer to
the temperatures you want.
few hours to reach the appropriate temperature.
You can store food and drinks in the refrigerator
after the temperature is suffi ciently cool.