Rack Mounting Procedure - Cisco C880 Hardware Installation Manual

B.4 Rack Mounting Procedure
Please follow the steps below to mount C880 M4 cabinet on a 19-inch rack.
1.
2.
3.
4.
5.
6.
7.
8.
9.
10. As (2) in FIGURE B.3 shows, put the cage nuts to the front-both-side pillar for fixing C880 M4
11. Install C880 M4 cabinet into the rack.
12. With four knob screws shown in red circle on FIGURE B.6, fasten C880 M4 cabinet to the rack.
Check the installation position for C880 M4 cabinet.
Referring to FIGURE B.3 and FIGURE B.4, check the position to install rail, screw, binder, and
cage nuts.
Loosen a screw (3) shown in FIGURE B.5, and adjust the length of rail on left side.
Insert the knob, (4) in FIGURE B.5, into the rear rack post and adjust the position.
As (5) in FIGURE B.5 shows, fasten the left side rail to the rear rack post by using three
centering screws.
As (7) in FIGURE B.5 shows, fasten the left side rail to the front rack post by using three of M5
screw with plug washers.
Tighten the screw, (8) in FIGURE B.5, and adjust its length.
"B" in FIGURE B.4 shows, use two centering screws and fasten binder on the rear rack post.
Similarly, install the right rail and mounting binder.
cabinet.
FIGURE B.3 Position to install rail (front side)
26