Page 1
Serial Number 05007864 - 05999999 PB-650T Serial Number 05008330 - 05999999 WARNING DANGER Read rules for safe operation and all instructions carefully. ECHO provides this Operator’s Manual, which must be read and understood for proper and safe operation. X750005331 X7501128301 09/03...
NTRODUCTION Welcome to the ECHO family. This ECHO product was designed and manufactured to provide long life and on-the-job- dependability. Read and understand this manual. You will find it easy to use and full of helpful operating tips and SAFETY messages.
Locate these safety decals on your unit. Make sure the decals are legible and that you understand and follow the instructions on them. If a decal cannot be read, a new one can be ordered from your ECHO dealer. See PARTS ORDERING instructions for specific information.
Proper clothing and safety gear must be worn when operating a blower. Physical Condition Hearing Protection Your judgment and physical dexterity may not be good: ECHO recommends wearing hearing protection whenever • if you are tired or sick, unit is used. • if you are taking medication, •...
OWER LOWER PERATOR ANUAL EXTENDED OPERATION EXTREME CONDITIONS Vibration and Cold To reduce the risk of RSI/CTS, do the It is believed that a condition called Raynaud’s Phenomenon, which following: affects the fingers of certain individuals, may be brought about by exposure to vibration and cold.
SAFE OPERATION WARNING DANGER Do not operate this product indoors or in inadequately ventilated areas. Engine exhaust contains poisonous emissions and can cause serious injury or death. Noise Control Determine Operation Area • Follow local noise regulations on sound • Review area to be cleared. Look for potential hazards such as stones levels and hours of operations.
PB-650T WARNING DANGER Never perform maintenance or assembly procedures with engine running or serious personal injury may result. INSTALL BLOWER PIPES 1. Assemble clamps (A) onto both ends of flexible pipe (B). 2. Assemble swivel pipe (C) into flexible pipe (B). NOTE Assure throttle cable is not twisted before installing handle (F).
Echo premium Power Blend Universal 2-Stroke Oil may be mixed approved fuel storage container. at 50:1 ratio for application in all Echo engines sold in the past regardless of ratio specified in those manuals. Storage - Fuel storage laws vary by locality.
• Recoil starter: Use short pulls - only 1/2-2/3 of rope length for starting. Do not allow the rope to snap back in. Always hold the unit firmly. • (PB-650H): Rotate spring loaded throttle arm downward to a comfort- able operating position. STARTING COLD ENGINE...
Slide stop switch (B) to Stop position. WARNING DANGER If engine does not stop when stop switch is moved to STOP position, close choke - COLD START position - to stall engine. Have your ECHO dealer repair stop switch before using blower again.
1. Use only during appropriate hours. 2. Allow the engine to warm up at a fast idle for a few minutes. PB-650H 3. Set engine speed with throttle lever (A). 4. Use lower speed to blow dry leaves from walks, patios and drives.
ECHO Service Dealer for maintenance. To help you decide whether you want to DO-IT-YOURSELF or have the ECHO Dealer do it, each maintenance task has been graded. If task is not listed, see your ECHO Dealer for repairs.
AIR FILTER Level 1. Tools required: 25 - 50mm (1 - 2 in.) cleaning brush Parts required: Repower Tune Up Kit P/N 90070 NOTE Clean daily. 1. Close choke (Cold Start Position). This prevents dirt from entering the carburetor throat when the air filter is removed. Brush accumulated dirt from the air cleaner area.
OWER LOWER PERATOR ANUAL SPARK PLUG Level 1. Tools required: 19mm Spark Plug deep socket, Feeler gauge Parts Required: Repower Tune Up Kit P/N 90070 1. Remove spark plug , and check for fouling, worn and rounded center electrode. 2. Clean the plug or replace with a new one. DO NOT sand blast to clean.
The cylinder exhaust port must be inspected and cleaned of excess carbon every 3 months or 90 hours of operation in order to maintain this engine within the emissions durability period. ECHO strongly recommends that you return your unit to your ECHO dealer for this important maintenance service.
High Altitude Adjustment High altitude adjustment is not required for proper operation of this engine. Level 2. Tools required: Screwdriver, tachometer (Echo P/N 99051130017) Parts required: None. NOTE Do not adjust carburetor unless necessary. If you have difficulty, see your ECHO dealer.
2. Place the stop switch in the “STOP” position. 7. Remove the spark plug and pour 7cc (1/4 oz.) of fresh, clean ECHO 2-stroke engine oil into the 3. Remove accumulation of grease, oil, dirt and debris cylinder through the spark plug hole.
• Purchasing from your Echo Dealer. • Manuals are available by sending a written request stating the model number and serial number of your Echo unit, part number of the manual, your name and address, and mail to the address below.