D-Link DXS-3600 Series Hardware Installation Manual page 25

Set the terminal emulation software as follows:
 Select the appropriate serial port (COM1 or
COM2).
 Set the data rate to 115200 baud.
 Set the data format to 8 data bits, 1 stop bit, and
no parity.
 Set flow control to none.
 Under Properties, select VT100 for Emulation
mode.
 Select Terminal keys for Function, Arrow and Ctrl
keys. Make sure to use Terminal keys (not
Windows keys) are selected
NOTE: When using HyperTerminal with the Microsoft® Windows® 2000 operating system,
ensure that Windows 2000 Service Pack 2 or later is installed. Windows 2000 Service Pack 2
allows use of arrow keys in HyperTerminal's VT100 emulation. See www.microsoft.com for
information on Windows 2000 service packs.
After correctly configuring the terminal, plug the power cable into the power receptacle on the back of the switch. The
boot sequence will appear in the terminal.
DXS-3600 Series 10GbE Layer 2/3 Switch Hardware Installation Guide
Figure 4-1 COM1 Properties – Port Settings
Figure 4-2 COM1 Properties – General Settings
25