Table of Contents
Advertisement
5) SATA3 0/1/2/3/4/5/6/7 (SATA 6Gb/s Connectors)
The SATA connectors conform to SATA 6Gb/s standard and are compatible with SATA 3Gb/s and SATA 1.5Gb/s
standard. Each SATA connector supports a single SATA device. The AMD Chipset supports RAID 0, RAID 1,
RAID 5, RAID 10, and JBOD. Refer to Chapter 3, "Configuring a RAID Set," for instructions on configuring a
RAID array.
1
SATA3
1
7
7
1
0
SATA3
6) F_PANEL (Front Panel Header)
Connect the power switch, reset switch, and system status indicator on the chassis to this header according
to the pin assignments below. Note the positive and negative pins before connecting the cables.
Power/
Sleep LED Power Switch
2
10
1
9
Hard Drive
Reset Switch
Activity LED
The front panel design may differ by chassis. A front panel module mainly consists of power switch, reset switch,
power LED, hard drive activity LED and etc. When connecting your chassis front panel module to this header,
make sure the wire assignments and the pin assignments are matched correctly.
DEBUG
1
PORT
Pin No. Definition
1
DEBUG
7
SATA3
PORT
2
3
4
6
SATA3
5
6
7
7
4
SATA3
5
7
1
7
1
1
7
1
7
2
SATA3
3
• PLED(Power/Sleep LED):
System Status LED
S0
On
S3/S4/S5
Off
• PW (Power Switch):
Connects to the power switch on the chassis front panel. You may configure
the way to turn off your system using the power switch (refer to Chapter
2, "BIOS Setup," "Power Management," for more information).
• HD (Hard Drive Activity LED):
Connects to the hard drive activity LED on the chassis front panel. The
LED is on when the hard drive is reading or writing data.
• RES (Reset Switch):
Connects to the reset switch on the chassis front panel. Press the reset
switch to restart the computer if the computer freezes and fails to perform
a normal restart.
• NC:
No connection.
- 14 -
GND
TXP
TXN
GND
RXN
RXP
GND
To enable hot-plugging for the SATA ports, refer
to Chapter 2, "BIOS Setup," "Peripherals\SATA
Configuration," for more information.
Connects to the power status indicator on the
chassis front panel. The LED is on when the
system is operating. The LED is off when the
system is in S3/S4 sleep state or powered
off (S5).
Advertisement
Table of Contents
