Table of Contents
Advertisement
Before the 1st washing
The washing machine was thoroughly tested before leaving the
factory. In order to remove any water which may be left over from
the test, run the first washing cycle without any laundry.
The washing machine must have been installed and connected
²
properly. See chapter Installing from~ Page 38
Check the machine.
1.
Never switch on a damaged machine. Inform your customer
²
service. ~ Page 35
Insert mains plug.
2.
Turn the tap on.
3.
Switch on the appliance.
4.
Close the washing machine door (do not load any laundry).
5.
Select the
6.
Select the temperature 90 °C.
7.
Open the detergent drawer.
8.
Pour approx. 1 litre of water into dispenser II.
9.
Add standard detergent to dispenser II according
10.
to manufacturer's instructions for light soiling.
To prevent frothing, use only half the recommended amount of
²
detergent. Do not use any woollens or mild detergents.
Close the detergent drawer.
11.
Select
12.
Switch off the appliance at the end of the programme.
13.
Your washing machine is now ready to use.
Cottons programme.
i ü
A
Start/Reload.
47
Advertisement
Table of Contents
