Out Of Range; No Remote Output; Feature Not Available - Clifford 5906X Owner's Manual

Out of Range

Each time a command is performed the remote will expect a command
response from the system. If a command response is not received the
OUT OF RANGE

No Remote Output

Occasionally when a command is performed the remote may not
generate a command response output or Out of Range output. This
indicates that the system received the command but it was an incom-
plete command (e.g. AUX button press too short to activate the trunk
release) or it was an illegal message (e.g. the command was cor-
rupted due to local RF interference). These are temporary normal func-
tions of the system and remote, perform the command again within 10
seconds to return to normal operation.

Feature not Available

The
FEATURE NOT AVAILABLE
cause and solution depending upon the command used:
Command
Runtime Reset Remote Start is Off
Sensor Bypass System is not armed
Defroster Remote Start is Off.
Not configured for
this.
Car Select Car 2 name tag is
not set.
Car 1 or Car 2 is out
of range.
© 2016 Directed. All rights reserved.
screen and tone plays as an alert.
message is a generic one which varies in
Cause Reason/Solution
Only available when Remote Start is On
Only available when system is armed
Only available when Remote Start is On.
Only available when configured for
Defroster control.
Set Car 2 name tag to activate Car 2
capability.
Move to within range .
47