Table of Contents
Advertisement
Steps
1. Locate the battery socket.
CAUTION:
To avoid damage to the battery connector, you must firmly support the connector while installing or
removing a battery.
2. Use a plastic scribe to pry out the system battery.
Figure 99. Removing the system battery
3. To install a new system battery, hold the battery with the positive side facing up and slide it under the securing tabs.
4. Press the battery into the connector until it snaps into place.
Figure 100. Installing the system battery
Next steps
1. If removed,
install the low profile or full height X1 expansion card
2. If applicable, connect the cables to the expansion card(s).
3.
Install the air
shroud.
4. Install the
system
cover.
5. Place the system into the rack. For more information, see the Rail Installation Guide at www.dell.com/xcseriesmanuals.
6.
Open the drive
bays, install
7. Install the
power supply
8. Follow the procedure listed in
9. While booting, press F2 to enter the System Setup and ensure that the battery is operating properly.
10. Enter the correct time and date in the System Setup Time and Date fields.
110
Installing and removing system components
all
drives, and then
close the drive
units.
After working inside your
risers.
bays.
system.
Advertisement
Table of Contents
