Table of Contents
Advertisement
Setting up your dishwasher
STEP3. Leveling the dishwasher
1. You can adjust the height of the product by turning the legs.
-
Slightly lift up the front and back of the product and turn the legs to adjust the height.
-
You can adjust the height up to 40 mm.
2. Push the product into the space under the sink and make sure that the product is level using the leveler.
-
Take care that the hoses or power cord is not twisted. when you push the product into the space
under the sink.
3. Install the product so that there is a space of at least 4 mm between the top of the product and the
bottom of the top plate of the sink.
After the installation, do not bind the power cord with a cable tie that has a metal wire in it.
CAUTION
Preparing the dishwasher
1. Push half the product into the space under the counter top.
If you push the entire product under the counter top, you will not be able to adjust both the front
legs of the product in the next STEP.
2. Prepare the power cord, water supply hose and drain hose.
•
Take care that you do not bend or fold the cord or hose.
•
Do not connect the power cord until the installation of the dishwasher is complete.
CAUTION
3. Pull the power cord, water supply hose and drain hose through the hole to the sink as shown by the
fi gure above.
FS_DW9000H-00158A-08_EN.indd 20
FS_DW9000H-00158A-08_EN.indd 20
English - 20
2016-08-12
2016-08-12
5:20:32
5:20:32
Advertisement
Table of Contents
