3000 Series Doors; Door Alignment And Adjustment - U-Line WINE CAPTAIN U-3018WCOL-01 Use & Care Manual

7 3000 Series Doors

Door Alignment and Adjustment

Align and adjust the door if it is not level, or is not sealing properly.
If the door is not sealed the unit may not cool properly, or
excessive frost or condensation may form in the interior.
IMPORTANT IMPORTANT
Properly aligned, the door's gasket should be firmly in
contact with the cabinet all the way around the door (no
gaps). Carefully examine the door's gasket to assure that
it is firmly in contact with the cabinet. Also make sure the
door gasket is not pinched on the hinge side of the door.
WARNING
• Do not attempt to use the door to raise or pivot
your unit. This would put excessive stress on the
hinge system.
• Pay special attention to the Cable Arm. Make sure not
to over extend or damage it during door alignment.
Stainless Models (Removing Wrap)
1. Open door completely.
2. Remove the two wrap screws from the bottom of the stainless
steel door wrap.
Wrap Screws
Cable Arm
13
3. Gently pull bottom of wrap away from door.
4. The Wrap hinges on top of the door. Carefully pull wrap away
and then up. See below.
Door Top
Door Bottom
5. If door being adjusted houses the
display unit, remove cable from
display by pressing in the release tab
on the cable connector.
Alignment and Adjustment
1. Using a T-25 Torx Bit, loosen each
pair of Torx head screws on both the upper and lower hinge
plate.
2. Square and align door as necessary.
3. Tighten Torx head screws on hinge.
4. If necessary re-connect display and re-install stainless steel wrap.
U-Line 3000 Series Maintenance
Step 2
Step 1
T-25 Torx Screw
T-25 Torx Screw
Press Tab Down