Connect The Gas Line - Superior Fireplaces DRT3535DEN Installation And Operation Instruction Manual

Innovative Hearth Products
DRT/DRC3500 Series Direct-Vent Gas Fireplaces
4. Connect the black power supply wire to the lower
outlet's black and red pigtail lead (Figures 30 and
31). Connect the white power supply wire to the
outlet's common terminal.
5. Connect the ground supply wire to the pigtail lead
attached to the outlet's green ground screw. Restrain
the inlet power lead per NEC or local codes.
6. If a wall-mounted ON/OFF control or thermostat is to be
used, mount it in a convenient location on a wall near the
fireplace.
NOTE: The supplied 15 ft of 6-conductor wire has
one end of each conductor connected to the control
circuit and the other end of each conductor placed
loose inside the bottom compartment.
7. After the wiring is complete, replace the cover plate.
Electronic models of these appliances are equipped with a three-prong (grounding)
plug utilized in connecting the electronic components to the junction box in the lower
compartment. This grounding plug provides protection against shock hazard and should be
plugged directly into a properly grounded three-prong receptacle. DO NOT cut or remove the
grounding prong from the plug.

Connect the Gas Line

13.
All codes require a shutoff valve mounted in the supply line. Figure 32 illustrates two methods for connecting the gas
supply. The flex-line method is acceptable in the U.S., however, Canadian requirements vary depending on locality.
Installation must be in compliance with local codes.
Figure 30 - Wiring Diagram—Junction Box
Green
White
Black
Tab
Intact
Tab Intact
Hot Side of
Receptacle
Green
Neutral
Ground
Side of
Screw
Receptacle
WARNING
Installation
900298-00, 02/2018
Ground - Green
Neutral - White
120 VAC - Black
(Power
Junction Box Supply
Unswitched)
Red
J-BOX / RECEPTACLE
WIRING 120V, 60HZ, 1PH
Field Wired
Factory Wired
39