Depth Gauge - Bosch GSR18V-755C Operating/Safety Instructions Manual

2610045251.qxp_GSB18V-755C GSR18V-755C 6/25/18 11:01 AM Page 13
To remove the battery pack, press the battery
pack release button and slide the battery pack
forward (Fig. 12).
Press the battery pack release button again and
slide the battery pack completely out of tool
housing (Fig. 12).

DEPTH GAUGE

Your drilling depth can be pre-set and/or repeated
by using the depth gauge.
Setting depth: After the auxiliary handle is
installed, make sure the drill bit has been fully
inserted into the chuck before setting the depth
gauge.
To adjust depth, turn the wing nut counter-
clockwise to loosen depth gauge, slide depth
gauge to desired depth X and securely tighten
wing nut clockwise (Fig. 13).
TEMPERATURE OVERLOAD PROTECTION
Avoid using battery operated tools continuously,
for long periods of time, while subjecting the tool
to overload conditions, such as drilling with large
diameter accessories into hard materials. Using
battery powered tools at extreme loads, may
cause the battery to exceed its allowable
FIG. 12
BATTERY PACK
RELEASE BUTTON
DEPTH
GAUGE
X
operating temperature range. When the battery
exceeds normal operating temperature caused by
overload, the speed of the tool may be reduced
and the tool may appear to lose power. To regain
the tool's full performance, the battery must be
allowed to cool, until the operating temperature
returns to normal.
SAVE THESE INSTRUCTIONS
FIG. 13
WING
NUT
DRILL BIT
13