Transportation, Storage And Disposal - Husqvarna LC 118 Operator's Manual

Problem
There is misfire in the engine
when it operates at high
speed.
Unusual noises from the en-
gine during normal load.
The engine does not operate
smoothly at idle speed.
There is too much vibration in
the handle.
The grass is not cut into
mulch.
The grass is cut irregularly.
The drive system does not op-
erate correctly (LC 419SP)
Transportation and storage
• For storage and transportation of the product and
fuel, make sure that there are no leaks or fumes.
Sparks or open flames, for example from electrical
devices or boilers, can start a fire.
• Always use approved containers for storage and
transportation of fuel.
• Empty the fuel tank before you put the product in
storage for a long period of time. Discard the fuel at
an applicable disposal location
• Safely attach the product during transportation to
prevent damage and accidents.
14
Possible cause
The electrode gap in the spark plug is
too small.
Incorrect type of gasoline.
The spark plug is dirty, defective or the
electrode gap is too wide.
The carburetor must be adjusted.
The air filter is dirty.
A blade is loose or not balanced.
A blade is bent.
The grass is wet.
The grass is too high.
One or more of the blades are not suffi-
ciently sharp.
The wheels are not in correct position.
One or more of the blades are not suffi-
ciently sharp.
The drive belt is not sufficiently tight or
there is dirt on the pulleys or drive belt.

Transportation, storage and disposal

Solution
Adjust the electrode gap.
Drain the fuel tank and the carburetor.
Refuel with new gasoline. Refer to
the problem continues speak to your lo-
cal service dealer.
Adjust the electrode gap or replace the
spark plug.
Adjust the carburetor.
Clean the air filter.
Tighten the blade bolts. Replace the
blades if there are damages.
Replace the blades if there are dam-
ages.
Do not operate the product when the
grass is wet. Wait until the grass is dry.
Cut first with the cutting height set high.
Lower the cutting height and cut again.
Cut only ½ of the cutting width at a time.
Sharpen or replace the blades.
Set the cutting height at the same level
for all 4 wheels.
Sharpen or replace the blades.
Let an approved service agent do main-
tenance on the drive system.
• Keep the product in a locked area to prevent access
for children or persons that are not approved.
• Keep the product in a dry and frost free area.
Disposal
• Obey the local recycling requirements and applicable
regulations.
• Discard all chemicals, such as engine oil or fuel, at a
service center or at an applicable disposal location.
• When the product is no longer in use, send it to a
Husqvarna dealer or discard it at a recycling
location.
# . If
1434 - 001 -