Registration (Pairing) - Motorola MBP25-2 User Manual
Hide thumbs
Also See for MBP25-2:
- User manual (30 pages) ,
- Quick start manual (8 pages) ,
- Quick start manual (6 pages)
Table of Contents
Advertisement
3.
Once the baby and parent units are switched on, the display on the parent
unit will show the video captured by the baby unit.
4.
If there is no connection or you are out of range, the video display will go
off and the symbol
every 9 seconds. (If the unit is on scan
Move the parent unit closer to the baby unit until the link is re-established.
Press and hold the P POWER ON/OFF button, until the progress bar
5.
scrolls fully across, to turn OFF the parent unit.
NOTE
The battery icon
and it gives a beep every 16 seconds. The battery needs to be recharged.
battery pack takes about 16 hours to charge fully.
When charging
1.
If the parent unit is turned OFF, when the adapter is plugged in, it displays a
"mains plug" icon briefly, then a large battery icon with internal segments
cycling for 60 seconds, before the display goes blank, but the unit
continues to charge. The Blue LED at top left corner lights up to indicate
the adapter is plugged in.
2.
If the parent unit is turned ON, when the adapter is plugged in, the battery
icon in the screen's top right corner will show that the battery is charging by
cycling the internal segments. The segments stop cycling when the battery
is fully charge. The Blue LED at top left corner lights up to indicate the
adapter is plugged in.
2.4
Registration (Pairing)
The Baby Monitor camera is pre-registered to your Parent Unit. You do not need
to register it again unless the Baby Unit loses its link with the Parent Unit.
To re-register your Baby Unit, or register a new Baby Unit, follow the procedure
below:
1
button of the parent unit and then press the - DOWN button
1.
Press the
to select the ADD CAMERA icon
will pop up, press the + UP button or - DOWN button to select
2. 1 / 2 / 3 / 4
the desired Camera identification number and press the
10
will flash on the LCD display, and the unit will beep
turns RED and flashes to indicate that the battery is low,
the
1?
symbol displays.)
1
, and press the
button to confirm.
1
button to start
Getting Started
Advertisement
Table of Contents
