Installation Requirements; Tools And Parts; Location Requirements - Jenn-Air JGC3215GS Installation Instructions Manual

Tools and Parts

Gather the required tools and parts before starting installation.
Tools needed
Tape measure
■
Flat-blade screwdriver
■
#2 Phillips screwdriver
■
15/16" (24 mm)
■
combination wrench
Pipe wrench
■
Parts supplied
Gas pressure regulator
■
Burner grates (1)
■
Burner bases:
■
Single burner units (1)
Double burner units (2)
Burner caps (2)
■
Clamp brackets (2)
■
2 / " (6.4 cm) clamping screws (2)
1
■
2
Foam tape seal
■
Propane conversion kit: W11027216
■
Mounting bridge kit: W11031680
■
Parts needed
Check local codes and consult gas supplier. Check existing gas
supply and electrical supply. See the "Electrical Requirements"
and "Gas Supply Requirements" sections.

Location Requirements

IMPORTANT: Observe all governing codes and ordinances.
Do not obstruct flow of combustion and ventilation air.
It is the installer's responsibility to comply with installation
■
clearances specified on the model/serial/rating plate. The
model/serial/rating plate is located on the underside of the
cooktop burner box.
Do not unpack the burner grate and base(s) until after the
■
cooktop is installed to avoid scratching the cooktop.
The cooktop should be installed in a location away from
■
strong draft areas, such as windows, doors, and strong
heating vents or fans.
All openings in the wall or floor where cooktop is to be
■
installed must be sealed.
Cabinet opening dimensions that are shown must be used.
■
Given dimensions are minimum clearances.
Grounded and polarized electrical supply is required. See the
■
"Electrical Requirements" section.
Proper gas supply connection must be available. See the
■
"Gas Supply Requirements" section.
The gas and electric supply should be located as shown in
■
"Gas and Electric Connection Locations" in the "Location
Requirements" section so that they are accessible without
requiring removal of the cooktop.
IMPORTANT: To avoid damage to your cabinets, check with
your builder or cabinet supplier to make sure that the materials
used will not discolor, delaminate, or sustain other damage.

INSTALLATION REQUIREMENTS

Channel lock pliers
■
Marker or pencil
■
Pipe-joint compound
■
resistant to Propane gas
Noncorrosive leak-
■
detection solution
Mobile Home—Additional Installation Requirements
The installation of this cooktop must conform to the
Manufactured Home Construction and Safety Standard, Title 24
CFR, Part 3280 (formerly the Federal Standard for Mobile Home
Construction and Safety, Title 24, HUD Part 280). When such
standard is not applicable, use the Standard for Manufactured
Home Installations, ANSI A225.1/NFPA 501A, or local codes.
In Canada, the installation of this cooktop must conform with
the current standards CAN/CSA-A240—latest edition, or with
local codes.
Product Dimensions
B
A
A. 21" (53.3 cm)
B. 15" (38.1 cm)
C. 3
Gas and Electric Connection Locations
D
A. Gas pressure regulator (supplied)—
arrow pointed toward cooktop
B. 3 prong grounding type outlet with
correct polarity
C. Gas shut-off valve
D. 18" (45.7 cm) minimum
NOTE: Each unit must have a separate regulator (supplied).
B
A
C
/ " (8.3 cm)
1
4
A
B
C
C
3