Toothbrush Handle - Philips HX6733/83 Manual

sanitizing (select models)
- With the UV sanitizer you can clean your brush head after every use.
Discontinue use of the sanitizer if the UV light bulb remains on when the door is open or if the
Philips logo is broken or missing from the sanitizer. UV light can be harmful to the human eye
and skin. This device should be kept out of reach of children at all times.
Unplug the sanitizer and call Customer Service if the sanitizer gives off smoke or a burning
smell while it is operating.
1 After brushing, rinse the brush head and shake off excess water.
Do not place the travel cap on the brush head during sanitization.
2 To open the sanitizer door, press the door release button.
3 Place the brush head on one of the 2 pegs in the sanitizer.
- Make sure the bristles of the brush head directly face the light bulb.
Note: Only clean ProResults and HydroClean brush heads in the sanitizer.
4 Make sure the sanitizer is plugged into a live outlet of appropriate voltage.
5 Close the door and press the green power on/off button once to select the UV clean cycle.
Note: You can only turn on the sanitizer if the door is properly closed.
Note: The sanitizer stops if you open the door during the sanitizing cycle.
Note: The sanitizer cycle runs for 10 minutes and then automatically shuts off.
The sanitizer is in operation when the blue light glows through the Philips logo and the UV
,
clean LED flashes slowly.
When the sanitizing cycle is complete, the UV clean LED light turns solid green and the
,
sanitizer automatically shuts off.
Cleaning
Do not clean the brush heads, handle, charger, charger covers or the UV sanitizer in the
dishwasher.

Toothbrush handle

1 Remove the brush head and rinse the metal shaft area with warm water.
Do not push on the rubber seal on the metal shaft with sharp objects, as this may cause
damage.
2 Use a damp cloth to wipe the entire surface of the handle.
EnglisH
9