Advertisement
Advisor TouchScreen
Installing the power supply in an Advisor TouchScreen:
1.
Depending on the situation, it may be necessary to contact the central monitoring station before starting the installation.
2.
If an existing power supply is present, remove the screw from the securement tab (F in Figure 2) and unplug the power supply.
Disconnect the power supply from the back of the TouchScreen.
3.
Connect the dashed wire (H in Figure 2) with the + label to the + terminal on the power supply (G in Figure 2). Connect the
other wire to the - terminal on the power supply. Observe polarity. Note: The dashed line/writing side of the wire indicates
positive. Ensure consistency by wiring + to + and - to -. Unlike previous panels, this is a DC power supply and polarity
must be observed or damage may occur.
4.
Connect the new power supply barrel connector (I in Figure 2) to the back of the Advisor TouchScreen (J in Figure 2).
5.
Route the wire through the channel (K in Figure 2) in the back of the Advisor TouchScreen.
6.
Supply power to the panel as noted in Table 2.
Table 2: Powering the Panel
Installation
Action
US
1.
2.
Canada
Plug the power supply into the outlet.
All Other Installations
Follow regional requirements.
7.
If the central monitoring station was notified, inform them this operation is complete.
Power Supply Configuration and Programming
There is no configuration or programming required. To confirm the power supply is supplying power to the panel or TouchScreen:
1.
Press the System Status icon
2.
Verify the Power icon
"Troubleshooting" section.
Troubleshooting
Panel Will Not Power Up or Power Supply is Not Recognized
•
Verify the outlet is working properly.
•
Verify that the power supply is plugged in to the outlet and that it is not on a switched outlet.
•
Verify the power supply wires are connected properly (ensure polarity is correct) at the power supply and at the panel.
TouchScreen Will Not Power Up
•
Verify the outlet is working properly.
•
Verify that the power supply is plugged in to the outlet and that it is not on a switched outlet.
•
Verify the power supply wires are connected properly (ensure polarity is correct) at the power supply.
•
Verify the barrel connector is fully seated into the TouchScreen connector.
Advisor Power Supply Installation Sheet
On the new power supply, knock out the screw hole in the securement
tab.
Plug the power supply into the outlet and secure with the supplied
screw.
.
is displayed in the System Status. If the Power Supply icon is not displayed, see the
Note
Do not use the securement tab and screw.
3 / 4
Advertisement
