LG MC3283FMPG Service Manual page 15

H. FAN MOTOR ASSEMBLY / REMOVAL
1) Discharge the high voltage capacitor.
2) Disconnect the leadwire from fan motor, noise filter
and high voltage capacitor.
3) Remove the two screws holding the the suction guide
ASS'Y to the oven cavity and remove the high voltage
diode earth screw.
4) Remove the screw of the capacitor bracket.
5) Remove the two screws holding the fan motor ASS'Y
to the suction guide ASS'Y.
I. HIGH VOLTAGE CAPACITOR AND
DIODE REMOVAL
1) Discharge the high voltage capacitor.
2) Disconnect the leadwire from fan motor, noise filter
and high voltage capacitor.
3) Remove the screw holding the suction guide ASS'Y to
the oven cavity and remove the high voltage diode
earth screw.
4) Remove the screw holding the high voltage capacitor
bracket.
H.V.
Transformer
LGE Internal Use Only
J. REMOVING THE TURNTABLE MOTOR
1) Remove the turntable.
2) Remove the turntable shaft VERY CAREFULLY
3) Lay the unit down on its back.
4) Remove the turntable motor cover.
5) Disconnect the leadwire from the turntable motor
6) Remove the screw securing the turntable motor to
7) After repairing the motor, rotate the removed
8) Fit the turntable motor cover's projecting part to the
9) The taptite screw shall be used when a turntable
NOTE:
1. Remove the wire lead from the turntable motor
2. Be sure to grasp the connector, not the wires, when
Suction
Guide
H.V.
Capacitor
5-5
with a slotted screwdriver.
The turntable base cover is easily removed by
pinching the six parts with a wire cutting.
terminals.
the oven cavity ASS'Y
turntable motor cover.
base plate slit.
motor cover is secured with a screw.
VERY CAREFULLY.
removing.
Taptite Screw
Turntable Motor
Copyright © 2009 LG Electronics. Inc. All right reserved.
Only for training and service purposes
Wire Leads