Setting Up Showview System - Philips DVDR520H/05 User Manual

C E
HANNEL DITOR
Turning on or turning off TV channels manually
After you have performed the channel scanning process, you
may like to add or delete some of the TV channels. This function
allows turning on the channel not found at channel scanning or
turning off the channel found manually.
1. Press [p] [q] to select a TV Channel not found at
channel scanning and press [u].
2. Press [p] [q] to select "Turn on" and press
[OK]. The TV channel selected will be turned on.
To turn off the TV channel, move to "Turn off" and press [OK].
The TV channel selected will be turned off.
3. To turn on other TV channels, repeat step 2 to
complete the settings.
4. Press [t] [u][p] [q] to select "EXIT," press
[OK] to save the setting and exit the "Channel
Editor" menu.
Setting up the decoder
Follow the steps below to set the decoder on:
1. Press [p] [q] to select a TV Channel and press
[u].
2. Press [p] [q] to select "Set decoder" and press
[OK]. The decoder will be set on for the channel
selected.
To set the decoder off, move to "Set decoder" and press [OK].
The decoder will be set off.
4. To set the decoder on for other channels, repeat
step 2 to complete the settings.
5. Press [t] [u][p] [q] to select "EXIT," press
[OK] to save the setting and exit the "Channel
Editor" menu.
Setting up SHOWVIEW ® system
Thanks to this programming system, you no longer need to
tediously enter the date, programme number, start and end
times. All the information needed by the DVD recorder for
programming is contained in the SHOWVIEW ® programming
number. This 9-digit SHOWVIEW ® number is found in
most TV listings magazine.
Before setting up, confirm that the all cables are securely
connected.
Setting up the ShowView ® system
1. Press the [SOURCE] button to set TV as the
input signal source.
2. Press [EDIT] to display the "Channel Editor"
menu.
3. Press [p] [q] to go to a channel and press
[OK].
4. Press [t] [u] /[p] /[q] to go to "ShowView"
and press [OK].
The menu to enter GCN number is displayed.
5. Use the numbered buttons (1~9) to enter the
GCN number and press [OK] when done.
Press [t] [u] to go back to advance/return to the previous/
next digit.
6. To set GCN numbers for other channels, repeat
step 5.
7. When complete, press [p] / [q] to go to "EXIT"
and press [OK] to exit the channel editor meun.
VPS/PDC
"VPS" (video programming system)/ "PDC" (program
delivery control) are used to control the start and
duration of TV channel recordings. If a TV program starts
earlier or ends later than was scheduled, the DVD
recorder will then turn on and off at the correct time.
Refer to "Recording TV programs using the
SHOWVIEW ® system" section for details about setting.
Note:
1. You must enter the start time exactly to the minute. If you
want to program a time that is different from the VPS/PDC
time, you must switch off VPS/PDC.
2. Only on TV program of a TV channel can be controlled using
"VPS/PDC" at a time. If you want to record two or more TV
programs on a TV channel using "VPS/PDC," you need to
program these as two separate recordings.
3. Since the DVD recorder requires a certain lead time for
getting the disc up to speed and positioning the laser before
recording can start, it is possible that the recorder will miss
the first few seconds of a TV show recorded with VPS/PDC.
In this case, disable VPS/PDC and enter a start time one
minute earlier.
15