Table of Contents
Advertisement
•
[Component Video]: Selects the
component video resolution. Copy-
protected DVDs can display only
480p/576p or 480i/576i.
•
[Blu-ray 3D video]: Selects the
3-dimensional video output when you
play a 3D video on your home theater.
The home theater must be connected
to a 3D TV through HDMI.
•
[Picture Settings]: Selects a predefined
color setting.
5
Press OK to confirm your choice.
Note
•
The best setting is automatically selected for
the TV. If you change the setting, ensure that
the TV supports the new setting.
•
For settings related to HDMI, the TV must be
connected through HDMI.
•
For settings related to progressive or
component video, the TV must be connected
through Component Video.
Change audio settings
1
Press
(Home).
2
Select [Setup], then press OK.
3
Select [Audio], then press OK.
4
Select and adjust the following settings:
•
[Night Mode]: Selects quiet or full
dynamic sound. Night mode decreases
the volume of loud sounds and
increases the volume of soft sounds
such as speech.
•
[HDMI Audio]: Selects HDMI audio
format or disables HDMI audio output
for the TV.
•
[360Sound Setup]: Calibrates the
speakers to 360 degrees SOUND
SETTINGS when a calibration
microphone is connected to the home
theater.
•
[Speaker Setup]: Sets the volume level
and distance of each speaker to obtain
the best possible surround sound
based on your room setup.
5
Press OK to confirm your choice.
Note
•
For settings related to HDMI, the TV must be
connected through HDMI.
•
Night mode is available for Dolby encoded
DVD and Blu-ray discs (for models support
Blu-ray playback).
Set up surround sound
automatically
When you set up the home theater for the first
time, the setup menu prompts you to calibrate
your speakers for the best surround sound. If you
move your speakers or change the layout of the
room, calibrate the speakers again to continue
getting the best sound.
Before you start, make sure that the calibration
microphone is less than 5m from each of the
speakers. If it is more, set up your sound manually
(see 'Set up surround sound manually' on page 22).
1
Connect your speakers and subwoofer as
described in the Quick Start. For the best
surround sound, turn your rear speakers to
face your listening position.
2
Connect the calibration microphone to the
MP3 LINK connector on your home theater
and place it in your usual listening place, at
ear height.
EN
21
Advertisement
Table of Contents
