Epson SC-P8550D Series Setup Manual page 6

EN
Safety Instructions
Do not sit on the product or place any heavy objects on the product.
Be careful with small children. The printer could fall or tip over and cause an injury.
When transporting or storing the product, be sure that it is level: do not tilt it at an angle or
place it upside down.
Ink could leak.
Store the cutter in a location out of the reach of children.
The cutter's blade could cause an injury. Pay careful attention when replacing the cutter.
When connecting cables or optional accessories, make sure they are installed in the correct
direction and that you follow the procedures exactly.
A fire or an injury could occur.
Connect these items correctly by following the instructions in the manual.
When moving the product, make sure it is turned off, the power cable is unplugged from the
outlet, and all connecting cables have been removed.
If cables are damaged, an electric shock or fire could occur.
Be sure that your hands or hair do not get caught in the roll paper unit while it is operating.
Failure to observe this precaution could result in injury.
Except when moving the printer, make sure the two casters (wheels) at the front and the two
stoppers at the rear are secured.
If they are not secured, an accident could occur.
Do not put your hands inside the printer through the eject slot.
They could get caught in the product's moving parts, causing injury.
Notes on the Power Supply
To prevent ground leak accidents, connect to a grounded (earthed) outlet.
Connecting to anything other than a grounded outlet could result in electric shock or fire.
Use only the type of power source indicated on the printer's label.
An electric shock or fire could occur.
Do not use the plug if any foreign objects such as dust have adhered to the plug.
An electric shock or fire could occur.
Do not use any other power cables except for the cable supplied with the printer. Also, do not
use the power cable supplied with the printer for any other devices.
An electric shock or fire could occur.
!
Caution
!
Warning
Do not use the power cable if it is damaged.
An electric shock or fire could occur.
If the power cable is damaged, contact Epson Support.
Note the following points to avoid damaging the power cable.
❏ Do not modify the power cable.
❏ Do not place anything heavy on the power cable.
❏ Do not bend, twist, or pull forcefully on the power cable.
❏ Do not route the power cable near heaters.
Do not connect too many cables to the power outlet for the power cable.
The temperature could rise and cause a fire.
Connect the power cable directly to an outlet for domestic use.
Do not insert or unplug the plug with wet hands.
An electric shock could occur.
Make sure the blades on the plug are inserted completely into the power outlet.
An electric shock or fire could occur.
Unplug the plug regularly and clean between the blades and around the base of the blades.
If the plug is plugged in for an extended period of time, dust collects around the base of the blades
and a short circuit or fire could occur.
When unplugging the plug, grip the plug itself; do not pull the power cable.
If the cable is damaged or the plug is deformed, an electric shock or fire could occur.
If you are not going to use the printer for an extended period, unplug the printer for safety
reasons.
6
!
Warning
!
Caution