Advertisement
ENGLISH
6
Troubleshooting
This chapter summarises the most common problems you could encounter with the appliance. If
you are unable to solve the problem with the information below, visit www.philips.com/support
for a list of frequently asked questions or contact the Consumer Care Centre in your country.
Problem
The appliance does not
work.
When I use the grinder,
the coffee is too weak.
When I use pre-ground
coffee, the coffee is too
weak.
when I remove the jug
from the appliance while
it is brewing coffee.
The appliance continues
to drip long after the
brewing process has
ended.
Possible solution
Put the mains plug in the wall socket and press the on/off button on
the front of the appliance to switch on the appliance.
the local mains voltage.
Close the lid of the coffee bean chute.
is consistent with the amount of water in the water reservoir. Please
keep in mind that the coffeemaker uses all the water in the water
reservoir.
Use the strength select button to set the coffee strength to 'strong'.
When you use coffee beans, make sure you do not press the pre-
ground coffee button, as this switches off the grinder.
of water in the water reservoir.
with the amount of water in the water reservoir. Please keep in mind
that the appliance uses all the water in the water reservoir.
To increase the coffee strength, increase the amount of pre-ground
coffee or decrease the amount of water.
that the coffee does not reach its full taste before the end of the
brewing process. Therefore we advise you not to remove the jug and
pour out the coffee before the end of the brewing process.
The dripping is caused by condensation of steam. It is completely
normal that the appliance drips for some time.
If the dripping does not stop, the drip stop may be clogged. To clean
Advertisement
