Table of Contents
Advertisement
en Troubleshooting
Fault
Remnants of food on
tableware.
Detergent residue in
the appliance
Water marks on
plastic parts.
Wipeable or water-sol-
uble coatings are
present inside the ap-
pliance or on the
door.
38
Cause and troubleshooting
Top baskets on right and left are not set to same
height.
Set the top baskets on the left and right to the
▶
same level.
Lid of the detergent dispenser is blocked by items of
tableware parts and will not open.
Arrange tableware in the top basket tableware so
1.
the tab collecting tray is not obstructed by table-
ware.
→ "Arrange tableware", Page 27
Items of tableware are blocking the dispenser lid.
Do not place tableware or fragrance dispensers in
2.
the tablet collecting tray.
The lid of the detergent dispenser is blocked by the
tab and will not open.
Position the tab in the detergent dispenser cross-
▶
wise, not vertically.
Tabs are used in the quick or short programme. Dis-
solving time of the tab is not attained.
Select a more intensive Programme or use Powder
▶
detergent → Page 24.
Washing effect and dissolving performance are re-
duced after a prolonged storage time or detergent is
very lumpy.
Change your detergent → Page 24.
▶
Due to laws of physics droplet formation on plastic
surfaces is unavoidable. After drying water marks are
visible.
Select a more intensive programme.
▶
Position tableware at an angle.
▶
→ "Arrange tableware", Page 27
Use rinse aid.
▶
→ "Rinse aid", Page 23
Set the water softening system higher.
▶
Detergent substances are deposited there. These
coatings cannot generally be removed with chemicals.
Change your detergent → Page 24.
▶
Clean the appliance mechanically.
▶
White coating is deposited in the appliance interior.
Set the water softening system correctly.
1.
In most cases you will need to increase the setting.
Advertisement
Table of Contents
