Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Bosch SKS62E28EU
Summary of Contents for Bosch SKS62E28EU
- Page 1 SK...
-
Page 3: Table Of Contents
Table of contents Height of utensils ....13 Intended use ....4 Detergent . -
Page 4: Intended Use
Intended use Fault, what to do? ..22 Intended use Waste water pump ....22 I n t e n d e d u s e Fault table . -
Page 5: Delivery
Safety instructions Delivery The electrical connection conditions must correspond 1. Check the packaging and with the specifications dishwasher immediately for on the dishwasher rating plate 1b. damage caused in transit. Do not switch on a damaged If the power cord of this appliance, but contact your appliance is damaged, supplier. -
Page 6: In Daily Use
Safety instructions If you cannot obtain any In daily use information from Read and observe the safety the manufacturer, you must information and instructions not install the dishwasher for use on the packaging above or below these for cleaning and rinsing agents. appliances. -
Page 7: Disposal
Safety instructions Disposal Warning Risks to children! 1. Make redundant appliances unusable to prevent If fitted, use the childproof subsequent accidents. lock. An exact description can be 2. Dispose of the appliance in a found in the back of the enve n environmentally friendly lope. -
Page 8: Protection Of The Environment
Protection of the environment Protection of the Getting to know your environment appliance i o n P r o t e c t o f t e n v i r o n m e n t G e t t i t o k n o w y o u r a p p l i a n c... -
Page 9: Water Softening System/Special Salt
Water softening system/Special salt To change the setting: Water softening 1. Rotate programme selector 0 until system/Special salt the required value is indicated on the digital display @. W a t e r s o f t e n i s y s t e m / S p e c i s a l t 2. -
Page 10: Using Special Salt
Water softening system/Special salt Using special salt Switching off salt refill indicator/water softening Always refill with special salt system immediately before switching on the S w i t c h i n g o f f w a t e r s o f t e n i n g s y s t e m appliance. -
Page 11: Rinse Aid
Rinse aid 4. To prevent excessive foam formation Rinse aid during the next rinse cycle, remove any rinse aid which has run over with R i n s e a i d a cloth. As soon as the rinse-aid refill indicator X is lit on the fascia, there is still a rinse-aid reserve of 1-2 rinsing Setting amount of rinse aid... -
Page 12: Utensils
Utensils Loading the dishwasher Utensils U t e n s i 1. Remove large food remnants. It is not necessary to prerinse utensils Not suitable under running water. 2. Place the utensils so that Cutlery and utensils made of wood. –... -
Page 13: Basket
Utensils B asket 1B F olding spikes * B a s k e t F o l d i n g s p i k e s * depending on model The spikes can be folded down to improve arrangement of pans, bowls and glasses. -
Page 14: Detergent
Detergent Adding detergent Detergent 1. If the detergent dispenser 1R is still D e t e r g e closed, press the lock 1Z to open You can use tablets as well as powder the detergent dispenser. or liquid detergents for dishwashers, but never use washing up liquid. -
Page 15: Combination Detergent
Detergent Notes If the utensils are only lightly soiled, You will obtain optimum rinsing slightly less than the indicated amount and drying results by using solo of detergent is usually adequate. detergents and applying salt and rinse aid separately. Suitable detergents and care products If programmes are short, tablets can be purchased online may not have full cleaning effect... -
Page 16: Overview Of Programmes
Overview of programmes Overview of programmes p r o g r a m m e s O v e r v i e w o f The max. possible number of programmes is illustrated in this overview. The corresponding programmes and their arrangement can be found on the fascia. -
Page 17: Programme Selection
Additional options Programme selection Additional options o n a l A d d i t i o p t i o n s You can select a suitable programme according to the type of utensils and * depending on model degree of soiling. -
Page 18: Operating The Appliance
Operating the appliance Note Operating - for environmentally friendly operation the appliance of the dishwasher: The Eco 50° programme is a O p e r a t i i a n c e t h e a p p l particularly environmentally friendly programme. -
Page 19: End Of Programme
Operating the appliance 6. To delete the preselected starting Switching off the appliance time, press the button H until indicated on the digital display. Short time after the end of the You can change your programme programme: selection at any time until the 1. -
Page 20: Changing The Programme
Cleaning and maintenance Changing the programme Cleaning and maintenance When the START button 8 has been pressed, the programme cannot be C l e a n i a n d m a i n t e n a n c e changed. -
Page 21: Special Salt And Rinse Aid
Cleaning and maintenance Warning – Health hazard 3. Remove any residue and clean filters under running water. Never use other domestic detergents, e.g. containing chlorine! 4. Re-install filter system in reverse sequence and ensure that the arrow marks are opposite each other after Special salt and rinse aid closing the filter system. -
Page 22: Fault, What To Do
Fault, what to do? 3. Scoop out water, use a sponge if Fault, what to do? required. F a u l t , w h a t d o ? 4. Loosen screws on the pump cover (Torx T 20) and pull off. Experience has shown that you can rectify most faults which occur in daily operation yourself. -
Page 23: Fault Table
Fault, what to do? Fault table Fault Cause Remedial action “Check water supply” Supply hose kinked. Install supply hose without kinks. display h lights up. Tap turned off. Turn on the tap. Tap jammed or calcified. Turn on the tap. Flow rate must be min. - Page 24 Fault, what to do? Fault Cause Remedial action A different error code is A technical fault has probably Switch off appliances with the ON/OFF switch (. After a short time restart indicated on the digital occurred. display. the appliance. to : If the problem recurs, turn off the tap and pull out the mains plug.
- Page 25 Fault, what to do? Fault Cause Remedial action Utensils not dry. No or too little rinse aid in Refill rinse aid. the dispenser. Programme selected without Select programme with drying (see drying. Overview of programmes, Programme sequence). Water collecting in depressions Arrange utensils in a sloping position, on the utensils and cutlery.
- Page 26 Fault, what to do? Fault Cause Remedial action Food remnants Utensils placed too closely Arrange utensils with adequate clearance on the utensils. together, utensils basket between them ensuring that the spray jets overfilled. can reach the surface of the utensils. Prevent contact points.
- Page 27 Fault, what to do? Fault Cause Remedial action Washable or water-soluble Detergent substances are Change detergent brand. coatings in the container deposited. These coatings cannot Clean appliance mechanically. or on the door. usually be removed with chemicals (appliance cleaner, ...). If there is a “white coating”...
- Page 28 Fault, what to do? Fault Cause Remedial action Coloured (yellow, orange, Film formation consisting Check function of the water softening brown), easily removable of ingredients from food system (refill with salt) or, if using combined deposits inside remnants and substances from detergents (tablets), activate water the appliance (mainly the tap water (limescale), “soapy”...
- Page 29 Fault, what to do? Fault Cause Remedial action Rust spots on the cutlery. Cutlery not adequately rust- Use corrosion-resistant cutlery. resistant. Knife blades are frequently more severely affected. Cutlery will also rust if rusting Do not wash rusting parts. parts are rinsed at the same time (pan handles, damaged utensil baskets, etc.).
- Page 30 Fault, what to do? Fault Cause Remedial action Filling valves making Depends on domestic installation, No remedial action possible. striking noises. as appliance is not defective. No effect on appliance function. Knocking or rattling noise. If there is a low load, the water Load the appliance with more utensils jets strike the washing tank or distribute the utensils more evenly...
-
Page 31: Customer Service
Customer service Customer service Installation and connection C u s t o m e r s e r v i c e If you are unable to rectify the fault, l a t i o n I n s t a l a n d c o n n e c t i please contact your customer service. -
Page 32: Delivery
Installation and connection Delivery Installation Your dishwasher has been checked The required installation dimensions can thoroughly in the factory to ensure that it be found in the installation instructions. is in working order. This may cause Level the appliance. Ensure that the small water stains. -
Page 33: Electrical Connection
Installation and connection Inlet rate: Use only a residual current operated circuit-breaker which features Minimum 10 litres/minute the symbol ‚. Only this extension Water temperature: guarantees compliance with Note printing on the water inlet hose! the currently valid regulations. If models are marked with 25°, The appliance features a water the water temperature may be max. -
Page 34: Transportation
Installation and connection Transportation Empty the dishwasher and secure loose parts. Drain the appliance according to the following steps: 1. Turn on the tap. 2. Close the door. 3. Switch on ON/OFF switch (. 4. Select programme with the highest temperature. - Page 36 *9000917492* 9000917492 en (9310) 550EG...