Table of Contents
Advertisement
To replace the component, reverse the removal procedure.
Removing and replacing a drive backplane power cable
Procedure
1. Power down the servers.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the chassis.
3. If installed, disconnect the tube set.
4. Disconnect all peripheral cables from the servers and chassis.
5. Do one of the following:
Extend the chassis from the rack.
•
•
Remove the chassis from the rack.
6. Remove the access panel.
7. Remove all fans.
Removal and replacement procedures
41
Advertisement
Table of Contents
